THERMAL SYSTEMS
T4000 Heater Only gasoline 12v
SKU: AT4006In Stock
System and model labels help you browse. Confirm fitment before ordering.
Contact usDescription
T4000 Heater Only gasoline 12v. Cabin air heating. Catalogue model references: T4000. Confirm the model, configuration and connections before ordering.
Specifications
| SKU | AT4006 |
|---|---|
| Category | Heater Parts |
| Browse by system | VATIRO · T4000 |
| Specification as supplied | T4000 Heater Only gasoline 12v |
Installation
Prepare and secure: Choose a rigid base. Check clearance for ducts and maintenance. Position the supplied gasket and template before drilling. Separate the occupied cabin from the combustion area.
Distribute warm air: Keep the return-air route unobstructed. Secure ducts without crushing them and protect outlets from luggage. Avoid routing hot outlet air directly back into the inlet.
Install the fuel system: Secure the tank, pickup, filter and pump compatible with the selected variant. Cut tubing cleanly and insert both ends fully into the connection to prevent air bubbles. Keep fuel lines away from hot components.
Install combustion intake and exhaust: Use the supplied pipes. Secure their ends and route exhaust outside the vehicle, away from windows, doors and air inlets. Allow condensate drainage as specified for the installation; avoid water traps and contact with fuel lines.
Connect and test: Connect the protected harness and compatible AT1192 controller. Check polarity and voltage under load. Complete ignition, stable operation and the full shutdown cycle; check for odours, leaks and overheating.
Operation & Maintenance
| Operation | Before travel or overnight use: Check fuel, battery charge and air inlets/outlets. Remove snow, mud or luggage that could obstruct ducts. Verify exhaust does not terminate beneath a window, door or air inlet. |
|---|---|
| Operation | Start and adjust: Switch on with the compatible controller and let ignition finish. Select thermostat or constant-power operation only if available. Older rotary controllers and AT1192 may use different sequences. |
| Operation | During heating: Monitor warm air, odours and noise. Do not close ducts needed for minimum airflow. If a sensor in a warm-air pocket stops heating prematurely, correct its position rather than changing combustion settings. |
| Operation | Shutdown and storage: Stop using the controller and wait for cooling to finish before isolating the main power. Follow the T2000 monthly maintenance cycle and operating-hours guidance in its maintenance documentation. Confirm intervals for other versions with ATLOSON. |
| Maintenance | Before use, check power, fuel, ducts and leaks. After moving, inspect mounts and fittings. Before the season, perform a supervised test and inspect the circuit. Allow the shutdown cycle and cooling to finish before maintenance. Follow the variant’s manual for dismantling and intervals. |
Before You Buy
- Existing mounting interfaces, fuel, voltage and controller
Questions & Answers
What does reference AT4006 identify?
T4000 Heater Only gasoline 12v. Cabin air heating. Catalogue model references: T4000. Confirm the model, configuration and connections before ordering.
What should I check for T4000 Heater Only gasoline 12v?
Retained equipment: controller, pump and wiring harness. Catalogue associations are browsing references; confirm fitment for the delivered unit.
Warranty
Contact ATLOSON to confirm the applicable warranty for this reference. Burners are excluded from warranty coverage.